Manual

６-３-４ Alarm

※ This function is used to generate alarms through the Buzzer / PTZ Preset / e-mail / Relay / Spot / Popup in

case of an event. PTZ preset can be configured between 1-16.

※ Popup function is to inform event occurrence to the user through a warning window in the

real-time monitoring mode.

６-３-５ Duration

Setup Pre-Recording( On / OFF ), Post-Recording(5 / 10 / 15 / 20 / 60 / 150 / 300 seconds).

※in Pre-Recording, images of the last 7 seconds before the event occurrence are recorded.

６-３-６ Log

Setup On / Off for Motion / Sensor / Sound / Text Input.

６-４ Schedule

H-model series provide 4 different recording mode configurations. Each schedule mode can be set one week/24

hours and the recording follows the setting automatically.

[Figure 6-51. Schedule Window]

６-４-１ Schedule Setup

Select one schedule among Schedule1, Schedule2, Schedule3 and Schedule4.

(1) Selection Tip

① Select the day and time to be set by using the arrow keys.

② Select after moving the cursor onto Time(0-23) or Day(Sun. – Holiday) then the user can configure

the whole line at once.

③ Using the mouse can be easier.

(2) Holiday Registration

This feature is used to enable the user to set the holidays and schedule independently.

① Move to {Schedule}  {Holiday}.

※ If the date for the holiday and day of the week are the same in the {Schedule} menu,

the holiday setup will have priority over the date setup.

※ Designated holidays are marked with a red tag.

② On the Holiday Registration Window, select the date by using the arrow keys and the Select button

and press the Select button.

③ After setting the holiday, move to {Save} at the bottom of the menu. Afterward, press the Select b

utton.