Manual

57
[Figure 6-49. Motion Area Setup]
① Select Motion Area of each channel.
② It becomes the 1 channel division mode and rectangular boxes appear where motions occur. Drag
the yellow pixel cursor by using the mouse or the front button/remote controller and select pixels w
here motion detection doesn’t applied. The selected area turns brown.
③ Select Exit to finish.
(2) Motion Sensitivity : Lowest/Low/Middle/High/Highest.
(3) Sound Sensitivity : Lowest/Low/Middle/High/Highest
(4) Sensor Type : Select the sensor type.
(5) EOL : EOL Function Select (On / Off).
.
６-２-５ Relay
Select the relay type.
６-３ Recording
The Main setup is to configure the environment of record and system and major functions.
In the real-time monitoring, move to {Menu}  {Setup}  {Recording}
[Figure 6-50. Setup / Recording]