Instruction Manual

Digital Video Recorder User Manual

Fig 4-34 network configuration-network

Note: You may want to use a different port than the default HTTP port 80. If so,

you need to configure your DVR to use the port you want. After configured,

remember that you have to specify its port number in the URL (e.g. if you select

port 88, you access it using http://192.168.1.10:88).

Click “Default” button to restore the default setting; click “Apply” button to save the

setting; click “Exit” button to exit current interface.

4.7.2 Sub-stream

The interface of network sub-stream configure is shown in Fig 4-35. Select the

sub-stream parameters of each channel according to the following table.

Tick off “all” and then do relevant setup, user can set all channels with same

parameters.

Click “Default” button to restore the default setting; click “Apply” button to save the

setting; click “Exit” button to exit current interface.

Note: When you select resolution and fps, the system will display free CIF

frame rate.