Datasheet

User guide Menu
49
Setting parameters
(principle)
Before you begin setting the parameters, you should check which pa-
rameters your system requires. Furthermore it is recommended to print
out the status page which contains the actual valid parameter values
(see Printing out the status page, page 53).
The initial values, which are activated after switching on or after error
correction, are determined using the adjustable printer parameters. In
many cases these parameters are overwritten by means of a system ap-
plication.
Changed parameter settings are stored when the settings menu is exited
and retain their values when the printer is switched off.
Make sure that the printer is in menu mode (see section Calling up the
menu, page 46).
Press the USER 2 key to select next main menu or press the USER 1
key to select a previous main menu.
Press the STOP/EJECT key to enter to the Parameter select mode.
The LCD displays the respective parameter and MENU.
Press the USER 2 key to select a next parameter or press the USER 1
key to select a previous parameter.
Press the STOP/EJECT key to enter the MENU setting mode.
SETUP
PAPER
USER1 USER2STOP
/EJECT
SETUP
PAPER
USER1 USER2STOP
/EJECT
SETUP
PAPER
USER1 USER2STOP
/EJECT
SETUP
PAPER
USER1 USER2STOP
/EJECT