Datasheet

User guide Control panel
25
Key functions when powering on
STOP/EJECT key
Powering on the printer whilst holding the
STOP/EJECT key will activate “Hex
Dump” mode. Keep the STOP pressed until
the message Hex Dump NO PAPER ap-
pears on the LCD display.
Refer to the section Hex Dump, page 63, for a
description of how to activate/deactivate and
perform the test printout.
USER 2 key
Powering on the printer whilst holding the
USER2 key, and subsequently loading paper
on instructions from the LCD panel will allow
you to make a status print. This is a print of all
the parameter settings. Keep the USER2 key
pressed until the message Print StatusPage
Load Paper appears on the LCD display.
Refer to the section
Printing out the
status page, page 53, for further details on the
status page.
SETUP
PAPER
STOP
/EJECT
USER1
USER2
SETUP
PAPER
STOP
/EJECT
USER1
USER2