User's Manual

CONNECTING PHONES: TWO LINE PHONE - OPTION 2
Call Handling:
TalkSwitch extensions 111 and 112 are wired to a two line phone using a line
splitter. When a call is transferred to extension 111, line 1 on the phone will
show as active; similarly calls on extension 112 will show line 2 as active.
Through the software, you may configure each incoming line to ring any given number
of extensions, including all extensions. However, be careful if incoming line 1 is con-
figured to ring both extensions 111 and 112. An incoming call will ring both phone
lines at the same time. Instead configure incoming line 1 to ring extension 111, and
line 2 to ring extensions 112.
WWW.TALKSWITCH.COM 6
CONNECTING PHONES, FAXES AND DEVICES TO TALKSWITCH
E1 E2 E3 E4
TalkSwitch Jacks
Incoming
Phone Lines
Extensions 111 and 112
Line Splitter
To Tel. Line L2
To Tel. Line L1 or L1/L2
Ext 111
To Jack E1
Ext 112
To Jack E2
Single Line RJ-11 Jack
Male (4 pin)
L1 (2 pin)
L2 (2 pin)
Line Splitter
Line Splitter
L1 and L2 are single line (2 pin) female
connectors that join to a two line (4 pin) male
connector. A 4 pin female receptical will
indicate that you have a duplexer and not a
line splitter.
Connect the male end of the
line splitter into the telephone
jack labeled “L1/L2”
Each phone line is connected to the line splitter
via a single line RJ-11 cable. The jacks at the end
of the cables should have two pins.