User's Manual
AS-1 READER/WRITER User Manual Rev.1.0 7 / 9
Rev.1.0
TAKUMA SEIKO CO., LTD
6 Operation
6.1 AS-1 READER
Normal operation:
- Turn on the power.
- AS-1 READER can be read ID value (D7-D0) from RFID tag with /Clock = L.
- User system will be known an ID value by /Clock = L 100msec width.
Stop mode:
- AS-1 READER can be entered stop mode (low power consumption) by /Stop = L.
- Recommendation: If the AGV is not moving, set Stop mode (/Stop = L).
6.2 AS-1 WRITER
Write operation:
- Turn on the power.
- Put AS-1 WRITER above the ID tag you want to write.
- Set R/W switch to WRITE side.
- Press the CLEAR, UP, X10, DOWN button and select the number you want to
write ID address number.
CLEAR : ID write address to “000”.
UP : ID write address to 1 increase.
DOWN : ID write address to 1 decrease.
X10 : Hold down this button and press UP button then ID write
address to 10 increase. (DOWN is 10 decrease)
- Confirm WrADRS: xxx “OK” display by EXE button.
If writing was succeeded, EXE LED will light 100msec.
If writing was failed, LCD display will present Wr ADRS:xxx “NG” .
― ― ― Write mode ― ― ―
Wr ADRS: xxx