User Manual

ManualsBrandsTAKSTAR ManualsAnalog MixerTAKSTAR XR-1016FX Analog Mixer

c. REC MODE (see picture on the right)

While a USB drive is inserted via USB-A and mixer under USB playback mode

(i.e., green USB indicator glows), press and hold MODE button for 3 seconds to

enter REC mode. In this case, the REC indicator flashes red while recording normally.

Press and hold MODE button for 3 seconds again to pause recording (REC indicator

glows solid red). Again, press and hold MODE button for 3 seconds to exit REC mode

and start playback of the recorded file.

d. REC PLAYBACK MODE (see picture on the right)

While playing the recording file, the USB green light and the REC red light will be on

at the same time, and you can control the playback using PAUSE/PLAY/PREVIOUS

TRACK/NEXT TRACK. audio file. Press and hold the MODE button again for 3 seconds

to continue recording. During the recording process, press and hold the MODE

button for 3 seconds to pause recording. While paused, press the MODE button once

to return to Bluetooth mode, and start new operation or selection.

Both XR-1016FX and XR-1824FX are equipped with an internal PRO DSP FX board with 16 FX presets. Rotate

the EFFECTS KNOB to select among the 16 sound effects:

01. SMALL HALL 05. THIN PLATE 09. ANALOG DELAY 13. PHASER

02. LARGE HALL 06. PLATE 10. CHORUS VERB 14. GATED REVERB

03. SMALL ROOM 07. SPRING REVERB 11. STEREO CHORUS 15. FLANGER REVERB

04. BRIGHT ROOM 08. MULTITAP DELAY 12. FLANGER 16. VOCAL ECHO

Enrich your audio with any of the above preset effects.

DSP Effector

PLUG PINOUT DIAGRAM

XR-1016FX/XR-1824FX ANALOG MIXER

1/4'' Balanced TRS Mono Wiring

1/4'' Unbalanced TS Mono Wiring

Tip

Ring

Sleeve

Sleeve = Ground/Shield

Tip = Hot

Ring = Cold

Sleeve = Ground/Shield

Tip = Hot

Bal XLR Wiring:

1 = Shield (Ground)

2 = Positive (+/Hot)

3 = Negative (-/Cold)

XLR Connector

Sleeve

XLR Connector (Female)

XLR Connector (Male)

Sleeve Sleeve

Sleeve

Shield

Cold

Hot

Sleeve