User Manual

There are two buttons for monitoring settings. For the upper
button: when not pressed, it monitors the audio from MAIN L/R;
when pressed, it monitors audio from BUSSES. For the lower
button: when not pressed, it monitors audio from BUS 1/2; when
pressed, it monitors audio from BUS 3/4.
FX FADER
This fader controls the signal level from the internal DSP effector.
The mute button, when pressed, disables signal flow to the output
bus or main mix. The PFL button allows the current channel's signal
to be monitored by CTRL ROOM OUTPUT and PHONES OUTPUT.
The MAIN button allows the effect signal to be sent to the main
channel for mixing. The 1/2, 3/4 buttons allow the effect signal to
be sent to the stereo busses BUS 1/2 or BUS 3/4.
BUS 1/2, BUS 3/4 FADER
Faders BUS1/2 and BUS3/4 control the level of the stereo bus outputs.
BUS 1/2 and BUS 3/4 can be fed by each input channel to create stereo audio groups routed to the physical
BUS OUTPUTS. When the MUTE button is pressed, signal flow to the BUS output or main mix is disabled. The
MAIN button next to the BUS fader routes the BUS to the MAIN MIX. When the PFL button is pressed, the signal
present in the BUS can be monitored through speaker connected to CTRL ROOM OUTPUT or headphones
connected to PHONES OUTPUT.
MAIN FADER
This fader controls the level of the MAIN MIX.
PREVIOUS TRACK
PAUSE/PLAY
NEXT TRACK
BLUETOOTH (BT) MODE LED
USB-A PLAYBACK MODE LED
USB REC MODE LED
EFFECTS SELECTION (1-16) KNOB & MODE SELECTION BUTTON
EFFECT STATUS (1-16) DISPLAY
MONITOR SETTINGS
36
37
38
39
37 38 39
40
41 42
43
44
45
46
47
41
42
43
44
45
46
47
a. BT MODE (see picture on the right)
After power on, the BT indicator will flash for 2 minutes, awaiting Bluetooth
connection. Search for "Mixer BT" on your Bluetooth device and connect. Once
paired successful, the BT indicator will stay lit. You can then manually play media
inside your device using PAUSE/PLAY/PREVIOUS TRACK/NEXT TRACK. If without
Bluetooth connection within 2 minutes, the Bluetooth function automatically shuts
down and the BT indicator turns off. To re-try Bluetooth connection, press and hold
the MODE button for 3 seconds to activate Bluetooth pairing and establish connection.
b. USB MODE (see picture on the right)
When a USB drive is inserted via USB-A port, press the MODE button to switch to
USB playback mode. In this case, the USB indicator will light up, and you can play
media inside your USB drive using PAUSE/PLAY/PREVIOUS TRACK/NEXT TRACK.
Note: You cannot switch to USB playback mode by pressing the MODE button if no
USB drive is inserted via USB-A.
OPERATIONS
18
40
XR-1016FX/XR-1824FX ANALOG MIXER