User Manual

24
25
26
FOOT SWITCH
This 1/4" TRS connector is where the foot switch is connected. The
internal effect can be turned on and off through the foot switch. If the
internal effect channel has been muted, the foot switch will not work.
PHONES OUTPUT
This 1/4" TRS connector provides stereo headphone output. The
output volume of this channel is controlled by the PHONES volume
control knob.
L/R MAIN OUTPUT
There are two 1/4'' TRS balanced jacks and two balanced XLR
outputs for Left/Right outputs. 1/4" output can be connected with
Tip, Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced
connector. Its output level is controlled by MAIN FADER (39). Both
XLR and TRS outputs can be used at the same time.
CTRL ROOM OUTPUT
These 1/4" jacks are usually connected to the input amplifier or
headphone amplifier in the control room.
PHANTOM POWER (two on XR-1824FX)
This switch applies +48VDC to the XLR input connector to power mics
that require phantom power. If enabled, do not connect unbalanced
dynamic mics or other XLR input devices that cannot handle this
voltage.
FX TO AUX 1-3
This allows routing of signal in the FX return channel to AUX1-3 send.
AUX3 PRE/POST
This button sets whether the AUX3/FX signal is pre-fader or post-fader.
AUX 1-4 MASTER
These potentiometers control the AUX1-4 master level.
When PFL button is pressed, the signal present on the respective
individual aux output can be monitored through the speaker
connected to the CTRL ROOM OUTPUT (27) or the headphones
connected to the PHONES OUTPUT (25).
LEVEL LED
This 12-LED level meter helps to control the main mix output level.
Keep the output level below the "CLIP" LED to avoid signal overload
and distortion.
PFL ACTIVE LED
This LED illuminates when one or more of the PFL buttons are
pressed.
CTRL ROOM VOLUME
This is the level control of signal routed to the CTRL ROOM OUTPUT.
During regular use, the main channel mix signal is routed to this
output; when one or more PFL buttons are pressed, the PFL bus
signal is routed to CTRL ROOM OUTPUT and PHONES OUTPUT.
PHONES VOLUME
This knob controls the level of the headphone output. Set the
headphone volume level to the minimum (-∞) before connecting
and wearing headphones to avoid hearing damage.
27
28
29
30
31
32
33
34
35
24
25
26
27
28
29
30
31
32
33
34
35
36
37 38 39
8
PANEL
17
XR-1016FX/XR-1824FX ANALOG MIXER