User Manual

6
Reverberation Parameter Setting
Reverb to Music Volume: 0~100
Mic: Reverb Volume 0~100%, Polarity (+/−).
Direct: Reverb Direct Volume 0~100%, Polarity (+/−).
Reverb Time: 0~5,000ms.
Pre_Delay: 0~200ms.
Reverb HPF (MIC): 0~2,000Hz.
Reverb LPF (MIC): 0.5KHz~20.6KHz.
Reverb HPF (Music): 0~2,000Hz.
Reverb LPF (Music): 0.5KHz~20.6KHz.
Reverb Bass Attenuation
Reverb Treble Attenuation
Recall Preset
Press “Recall” to enter this screen, and press “Up” to display a blinking
cursor on the upper row, then turn the function knob to select which
preset (No. 1~15).
Press “'Recall” again to enter this screen, then either press “Up” to select
“No” to exit the recall interface, or press “Down” to select “Yes” to recall
the selected mode.
After you select “Yes” by pressing “Down”, wait on this screen for a few
seconds to finish the recall. Once finished, it will return to the home screen.
Note: Recall from a preset will override current parameters, please
save the current settings if necessary before recall.
Save Mode
Press “Save” to enter this screen, and press “Up” to display a blinking cursor
on the upper row, then turn the function knob to select which mode number to
save to (No. 1~15). Then press “Down” to move the cursor downwards, and
turn the function knob to set the mode name to save as.
Press “Save” again to enter this screen, then either press “Down” to select
“Yes” and save the mode, or press “Up” to select “No” and return to the main
screen without saving.
After you select “Yes” by pressing “Down”, this interface will show up, indicating
the operation is successful.
Note: Save function is only permitted in Admin mode, but not User mode.
EKX-5A
Professional Digital Audio Processor