User Manual

DG-U100
19
Cautions:
1) Check if the CU and the camera are wired correctly.
2) Check if the ID No. and Baud of the camera is set properly.
3) Whether the camera tracking function is enabled on the CU, and whether corresponding ID and
Camera Protocol are selected.
4) Whether the ID on the discussion unit is set correctly and issued to the camera.
5) It' s suggested to turn off the configured delegate unit before setting up a new one.
Press and rotate the knob to select the camera ID for use, then double-tap to issue the instruction
to camera. There will be an upward arrow appearing briefly after issuing the ID, and the camera
signal LED will flash to indicate successful binding and positioning. The mic unit screen will also
show the linked camera ID, as shown below:
发言代表 无
1
会议中
主席
641.00
315.00
11
8. System Wiring Diagram for Reference
Network Controller
Wireless Conference Microphone System