User Manual

DG-U100
15
3. Sync Units
Set the required frequency and priority before syncing frequency. Press and hold the SPEAK
button on the mic unit, and align the IR windows on both the mic unit and the CU; rotate the
CURSOR knob on CU to select SYN , then press the knob to start automatic sync, in which " "
case the CU IR window will flash red until the syncing is over. Once synced successfully, the CU
screen will display the Signal Meter and Mic Battery Status, as shown in Figure ⑤:
2. Select & Set Channel Priority
Rotate the CURSOR knob to move the cursor onto the box in Figure ②, and press the knob to switch
priority among "Chairman", "Guest", or "Delegate". For Chairman (11-14) and Guest (01-04) units,
their IDs will be automatically generated; while for Delegate units, you need to manually set their IDs.
This can be done by moving the cursor onto the box in Figure ③, press the knob, then rotate to set
the Delegate ID (21-100 optional) as shown in Figure ④.
SY N
646.50MHz
11
Figure ②
A
690.25MHz
DLGT
Figure ③
B
666.00MHz
Figure ④
C
21
Vol 31:
Cha.irman11
TxGa.in:06
SY N
Vol 31:
TxGa.in:
DLGT 21
SY N
Vol 21:
TxGa.in:06
640.00MHz
11
Figure ⑤
A
SY N
Vol 26:
Cha.irman11
TxGa.in:06
Wireless Conference Microphone System