Operation Manual

5
Connection
When connection your appliance be sure to correctly observe the following instructions:
● The outlet must be in the vicinity of the appliance and must be easily accessible.
● Only use the mains adapter on grounded sockets at 100-240V~AC, 50/60Hz. If you are
unsure about the power supply to the place of use, ask the relevant energy supplier.
● Use only the power adapter provided with your appliance.
● For additional safety, we recommend the use of a surge protector in order to protect your
appliance from damage of spikes or lighting strikes on the power network.
Power Through Car Adapter
● The car adapter should only be connected to the lighter socket of a car (car battery
DC12V ,no trucks(24V). If you are in any doubt about the power source in your car, contact
your car manufacturer.
Cabling
● Arrange cables so that no-one can tread on them or trip over them.
● Do not place any items on the cable.
WARNING
When the unit is not in use for a long time,
please switch the Power On/Off switch to unlock position and recharge the battery every
other time, otherwise the battery’s lifetime would be shortened.
INSTALLATION
The following guides you step by step through the initial set up of the navigation system.
Firstly, remove the foil for protecting the device during transportation from the display.
How to access to the navigation system
Press Sleep/Wake up button on the unit for about two seconds to wake up the unit (Note:
Sometimes the unit will not be woken up by reason of low battery, please charge the battery in
time.). The brand logo will appear and your device will display the application screen after a few
seconds.
Attention: According to the charging status of the accumulator installed.
It is necessary for the device to be charged before the initial setting up can run through.
Charging Battery of the Navigation system
You have different possibilities to charge the battery of your navigation system:
● With the help of the network adapter.
● By means of the car adapter.
● Don not interrupt the charging process before the battery is fully charged. It will take a few
hours for the navigation system is fully charged.
● Note: You can use the navigation system during the charging process, but the power supply
must not be interrupted during initial set-up.
● Leave the mains adapter connected to the navigation system for around 24 hours, so that the
backup battery can be fully charged.
● You can leave the main adapter connected, and this is very handy for continuous operation.
However, the mains adapter also requires power even when it is not charging up the battery