Operation Manual

13
Software Installation On Your PC
In order to be able to deploy self-defined cards on your navigation system you must install the
corresponding navigation software on your PC.
1. Before installing the navigation
software ensure that ActiveSync is installed and your navigation system is connected with your
PC via the ActiveSync-cable.
2. Place the CD 1 with the navigation software in your CD drive. The installation will start
automatically.
3. Follow the program instructions.
Installing Microsoft ActiveSync
In order to transfer your data between your PC and your navigation system you need the
Microsoft ActiveSync program.
The cost of the navigation system includes a license for this program
which can be found on the Support CD.
Attention: Important files can be overwritten or changed during the installation of software. You
should create a hard disk backup, in order to be able to have access to the original files in the
case of possible problems following the installation.
You must have administrator rights to install the software under Windows 2000/XP.
Attention: You should not connect the navigation system to your computer yet.
1. Insert the Support CD and wait until the program starts automatically.
Note: The Auto Run function is probably deactivated if it does not function. The Setup program
on the CD must be started, to start installation manually.
2. Choose the language, click then Install ActiveSync and follows the instructions on the screen.
3. Connect the navigation system to your computer with the assistance of the ActiveSync Cable,
while the connection options are checked. To do this, push the USB connector into a free USB
port on your computer.
The hardware installation assistant recognizes now a new appliance and installs a suitable driver
which can take some minutes. Repeat the die connection search if it fails the first time.
Follow the instructions on the screen. The program will now set up a partnership between your
PC and the device.
Note:
When the unit is on, if you press Sleep/Wake up button on the upper side of the unit,
“POWER OFF” will be displayed on the center of the screen for several seconds, then the
unit will be turned off.
When you charge the battery with the unit on, when you disconnect the plug “POWER
OFF” will be displayed on the center of the screen for several seconds, then the unit will
be turned off automatically.