Installation Guide

51 Page
Normal Operaon
Owner's Guide
NORMAL OPERATION
BUILT-IN CONTROLLER and REMOTE CONTROLLER

Temperature above 125 °F (52 °C) can cause severe burns or death from scalding.
Children, disabled and the elderly are at high risk of being injured.
WARNING
1. Open a cold water
fixture.
2. Mix hot water with the cold water
to get the correct temperature water.
3. When finished, close the
water fixtures.
 Flow rate to activate the water heater: 0.5 gallon per minute at the default set
temperature (1.9 L/min.)
 Flow rate to keep the water heater running: 0.4 gallon per minute (1.5 L/min.)
NOTICE
GENERAL
Built-in controller Remote controller
6 75
1
8
2
3
4
9
6 85
2
3
9
174
No. Description Note No. Description Note
1
"ON/OFF"
Button
Press this button to start or stop
operation.
5
"TIME"
Button
Press this button to set the
current time.
2
"HOT"
Button
Press the "HOT" button or the
"COLD" button to set the outlet
water temperature, the current
time, and PUMP TIMER.
6
LCD
The current time, set temperature,
error code and other information
are displayed.
3
"COLD"
Button
7
"PUMP"
Button
Press this button to set and con-
trol the pump operation.
4
"INFO."
Button
Press the "INFO." button to dis-
play the inlet & outlet water tem-
perature and water flow and set
the outlet temperature, pump
choosing, and unit conversion.
8
IN USE LED
The LED lights during combustion.
9
STAND BY LED
The LED lights when power is on.