Installation Sheet

60 Page
ADDITIONAL FEATURES
-Informaon mode-
You can get some information about the water heater condition by pressing the "INFO" button. For more
information, follow the procedures below:
Normal Operaon
Owner's Guide
Operation
Controllers
Built-in controller Remote controller
1.
Press the "INFO" button on the controller to enter the
information mode.
2.
Press the "INFO" button to display the inlet water
temperature.
Inlet water temperature
(EX.: 60 °F)
3.
Press the "INFO" button again to display the outlet
water temperature.
4.
Press the "INFO" button again to display the water
flow.
5.
Press the "INFO" button to exit the information mode.
Outlet water temperature
(EX.: 120 °F)
Water flow
(EX.: 3.5 GPM)
NOTICE
When installed on an indoor heater, the 100276687 (TM-RE43) has priority for set
temperature over the built-in controller.
-Unit conversion mode-
The remote controller has a function that can change units of temperature and flow rate from °F to °C and
from gallon per minute to liter per minute and vice versa. To change these settings, follow the step below:
Operation
Screen on the controller
Built-in controller Remote controller
1.
Press the "ON/OFF" button on the controller in order to
turn the controller on.
2.
When ON, the STAND BY LED is lit.
3.
The current set temperature and time will be
displayed on the screen.
4.
Press the "INFO" buttons for at least 3 seconds.
5.
The set temperature should now be displayed in the
alternate unit of measurement.
(EX.: 120 °F)
(EX.: 50 °C)