Installation Sheet

39 Page
TEMPERATURE REMOTE CONTROLLER
-Included accessories - Outdoor model only
Installaon
Installaon Manual
Fig. B
Be sure that the following items are included with the remote controller which comes with
Outdoor model.
Temperature
remote controller
Screws Manual Remote controller cable*
Qty: 1
Qty: 2 Qty: 1
Qty: 1
100276687 (TM-RE43)
It is also an optional accessory as a second remote for the indoor model. Refer to pp 9 and 10.
*The optional remote controller (100276687/TM-RE43) has no remote controller cable.
-Installaon-
This remote controller is NOT waterproof.
Do not install in high temperature environments, steamy conditions (such as a
bathroom), outdoors, in direct sunlight, or within the reach of children.
Make sure the remote controller does not come into contact with water or oil. Failure
to observe these warnings could result in electrical shock.
 Do not place the remote controller cable close to other wires from other products.
 Do not extend the remote controller cable more than 400 ft (122 m).
WARNING

1. Take the Frame off of the remote controller with a flat head screwdriver. (Fig. A and B)
2. Attach the Metal plate on the wall with two provided screws. (Fig. B)
3. If you use another cable, crimp the Fork terminals to the wires. (Fig. C)
Cut out (removed during later steps).
Frame
Main unit
Metal plateAached short screws
A + B
3-1/4 inch
(83.5 mm)
Hook B to the Fixing
bracket on A.
A
B
Fig. A
Press and twist flat
head screwdriver
against the cutout.
Twist
Remote controller cable
1-3/8 Inch
(35 mm)
Fig. C
1-5/8 Inch
(41 mm)
Fork
Terminals