T-M50-ASME-N Installation Manual

- 30 -
(Unit: °F)
Temperatures available under the High Temperature Mode* (Refer to p. 31 for details.)
(Unit: °F)
2. Press the HOT/COLD button to set
the water temperature up to 120 °F (50 °C).
NORMAL OPERATION
• Flow rate to activate the 910 (T-M50) : 0.5 gallon per minute
• Flow rate to keep the 910 (T-M50) running : 0.4 gallon per minute
WITHOUT REMOTE CONTROLLER
1. Open a cold water
fixture.
2. Mix hot water with the cold water to
get the suitable temperature water.
3. When finished, close
the water fixture.
WITH REMOTE CONTROLLER INSTALLED: 9007603005 (TM-RE30) (Optional)
1. Press the power ON/OFF button.
Increasing temperature from 120 °F (50 °C) to 140 °F (60 °C)
• Press the “HOT” button to set 120 °F (50 °C).
• Press and hold the “INFO” button and the “HOT” button for at least 3 seconds. The remote will emit
a beep and change to 125 °F (52 °C).
• Press the “HOT” button to set up to 140 °F (60 °C).
Increasing temperature above 140 °F (60 °C)
• Press the “HOT” button to set 140 °F (60 °C).
• Press and hold the “INFO” button and the “HOT” button for at least 3 seconds. The remote will emit
a beep and change to 145 °F (63 °C).
• Press the “HOT” button to set up to 175 °F (80 °C) or 185 °F (85 °C).
110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185
WARNING
Hot Water temperatures over 125 °F (52 ºC)
can cause severe burns instantly or death from
scalding.
• The outlet hot water temperature of the water heater is factory set at 120 °F (50 ºC).
• Feel the water temperature before bathing or showering.
100
105
110
115
120
125
130
135
140
145
150
155
160
165
170
175
(EX: 110°Ｆ)
The temperature and the
time will be displayed on
the remote controller.
Temperatures available under the Default Mode
3. Open a cold water fixture.
Mix hot water with the cold water to get the
suitable temperature water.
4. Close the water fixture.
When ON,
green LED is lit.
Lamp is OFF
Lamp is ON