Installation Guide/Owner's Manual

- 23 -
The dark squares indicate the direction
the dipswitches should be set to.
Temperature Settings
TEMPERATURE SETTINGS
• There are 4 preset temperatures that you can select from by changing the dipswitch settings on
the computer board.
• The temperature has been preset at the factory to 122°F (50°C).
• If you desire to change the set temperature with dipswitches, please refer to the diagram on
below. These temperatures are available: 113°F, 122°F, 140°F, 167°F.
• 140°F and 167°F are for heating applications only.
• If you desire a hot water temperature other than the 4 preset settings, please purchase the
optional temperature remote controller (part No. TK-RE02).
• With this optional TK-RE02 you can set the temperature from 99ºF to 167ºF with various
increments.
• Please read the instructions carefully prior to installing the TK-RE02, as failure to do so could
damage the temperature controller and/or the water heater, which will void the warranty.
• Turn off the power supply to the heater before changing the dipswitch settings.
• Only change the switches with the dark squares. The dark squares indicate
which direction the dipswitch should be set to.
To change dips
w
itch settings for
temperatures, locate the bottom
left corner of the computer
board.
Dipswitches