Instruction Manual

26 Page
Installaon
Installaon Manual
Fig.B
Back plate
3-1/4 inches
Attach the screws
Cut out the partition with pliers
Main body
Fig.A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
Only the outdoor model comes with the temperature remote controller, which is an
oponalaccessoryfortheindoormodel.
Check that these items below are included with the remote controller.
Temperature
RemoteController
Screws Manual RemoteControllerCable
Qty: 1 Qty: 2 Qty: 1
Qty: 1
TEMPERATURE REMOTE CONTROLLER
-INSTALLATION-
<MountingandWiringtheRemoteController>
1. Takeoffthe“Backplate” from the remote controller with a flat head screwdriver. (Fig.AandB)
2. Attachthe“Backplate” on the wall with the two provided screws. (Fig.B)
• ThisremotecontrollerisNOTwaterproof
Do not install in high temperature environments, steamy conditions (such as a
bathroom), outdoors, in direct sunlight, or within the reach of children.
Make sure the remote controller does not come into contact with water or oil.
• Do not place the remote control wiring close to other wires from other
products.
• Do not extend the remote control wiring more than 400 ft. (122 m).
CAUTION