Installation Sheet

27 Page

3. Tightenthetwo"Fork terminals" beneath the two "Remote controller terminal" screws on

the back of the main body. (Fig. C-1)

4. Cut out the inlet for the remote controller cable from the bottom of the main body. (Fig. C-2)

5. Placethe“Main body”backonthe"Back plate", with the "Remote controller cable" running

out of the bottom inlet.

1. Disconnectpowersupplyfromthewaterheater.

2. Takeoffthewaterheater’sfrontcover.

3. Locatetheremotecontrollerterminal,picturedtothenextpage(locatedaroundthelowerright-

hand side of the computer board).

4. Takeoffthebackplatefromtheremotecontroller,andthenattachthetwoforkterminalsto

connector base of the backside the remote controller with two screws. Make sure the terminals

are firmly fixed.

5. Pulltheremote’swiresthroughtheholeatthebottomofthewaterheater’scasing.

6. Properlyattachtheremote’swirestotheremotecontrollerterminalonthecomputerboard.

(No polarity)

 * Do NOT jump or short-circuit the wires or computer will be damaged.

7. ReplaceFrontCoversecurely.

8. Wiresusedfortheremotecontrollerconnectionmustbe:

• Minimum 20AWG wire (No polarity)

• Maximum 400 ft. (122 m) long

Remotecontroller

terminals

Fig. C-1

Two fork terminals

Remote controller cable

Inlet for the remote

controller cable

Cut out

Fig. C-2