Installation Sheet

26 Page
TEMPERATURE REMOTE CONTROLLER
-INCLUDED ACCESSORIES (Outdoor models only)-
-INSTALLATION-
<Mounting and Wiring the Remote Controller>
1. Takeoffthe“Back plate”fromtheremotecontrollerwithaflatheadscrewdriver.(Fig. A and B)
2. Attachthe“Back plate”onthewallwiththetwoprovidedscrews.(Fig. B)
Installaon
Installaon Manual
Fig. B
Back plate
3-1/4 Inch
Attached the screws
Cut out the partition with pliers
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
• This remote controller is NOT waterproof
Do not install in high temperature environments, steamy conditions (such as a
bath room), outdoors, in direct sunlight, or within the reach of children.
Make sure the remote controller does not come into contact with water or oil.
• Do not place the remote control wiring close to other wires from other
products.
• Do not extend the remote control wiring more than 400 ft. (122m)
CAUTION
Check that these items below are included with the remote controller.
Temperature
Remote Controller
Screws Manual Remote controller cable
Qty:1 Qty:2 Qty:1
Qty:1