Install Instructions

38 Page
ADDITIONAL FEATURES
-Informaon mode-
You can get some information about the water heater condition by pressing the "INFO" button. For more
information, follow the procedures below:
The remote controller has a function that can change units of temperature and flow rate from °F to °C and
from gallon per minute to liter per minute and vice versa, please follow the procedures below:
Outlet water temperature
Operation Screen
1.
Press the "ON/OFF" button on the remote in order to
turn the remote controller on.
2.
When ON, the STAND BY LED is lit.
3.
The previous set temperature will be displayed on the
screen.
4.
Press the "INFO" buttons for at least 3 seconds.
5.
The set temperature should now be displayed in the
alternate unit of measurement.
(EX.: 100 °F)
-Unit conversion mode-
Operation Screen
1.
First of all, inlet water temperature will be displayed on
the remote controller by pressing the "INFO" button.
2.
Outlet water temperature will be displayed on the
remote controller by pressing the "INFO" button.
3.
And then, water flow will be displayed on the remote
controller by pressing the "INFO" button.
4.
Press the "INFO" button to finish information mode.
Inlet water temperature
Water flow
Normal Operaon
Owner's Guide