Install Instructions

36 Page
NORMAL OPERATION
GENERAL
REMOTE CONTROLLER
Theillustraonbelowshowsanexampleofthedisplay.Theexactdisplaymaydierfromexamples.
"HOT" Button
"COLD" Button
"ON/OFF" Button
Press the "HOT" button or the
"COLD" button to set the hot
water temperature.
When the STAND BY LED is ON, the
hot water temperature will be
displayed.
Display for Temperature
Press this button to
start or stop operation.
"INFO" Button
STAND BY LED (Orange)
IN USE LED (Green)
The indicator is ON to show that
power is ON.
The indicator lights during combustion.
Each time the button is pressed,
the operation mode is selected
in the sequence of the following.
Inlet water
temperature
Outlet water
temperature
Water
flow
Temperature above 125 °F (52 °C) can cause severe burns or death from scalding.
Children, disabled and the elderly are at high risk of being injured.
CAUTION
The remote controller has an energy saving mode. Five minutes after the water
heater stops operating, the backlight of the remote controller turns off.
The backlight of the remote will turn back on once the water heater begins firing
again.
1. Open a hot water tap. 2. Mix cold water with the hot to get
the correct temperature water.
3. Close the hot water tap.
• Flow rate to activate the water heater: 0.5 gallon per minute at the default set
temperature (1.9 L/min).
• Flow rate to keep the water heater running: 0.4 gallon per minute (1.5 L/min).
NOTICE
Normal Operaon
Owner's Guide