Install Instructions

23 Page
3. Tightenthetwo"Fork terminals" beneath the two "Remote controller terminal" screws on
the back of the main body. (Fig. C-1)
4. Cut out the inlet for the remote controller cable from the bottom of the main body. (Fig. C-2)
5. Placethe“Main body” back on the "Back plate", with the "Remote controller cable" running
out of the bottom inlet.
<How to connect the remote controller to the water heater>
Remote controller
terminals
Fig. C-1
Two fork terminals
Remote controller cable
Inlet for the remote
controller cable
Cut out
Fig. C-2
1. Disconnectpowersupplyfrom
the water heater.
2. Takeoffthewaterheater’sfront
co ver.
3. Locatetheremotecontroller
terminal. (Refer to the Fig. D-1
and D-2.)
4. Opentheplasticcoverofthe
remote controller, and then
attach the two fork terminals to
connector base of the backside
of the remote controller with
two screws. Make sure the
terminals are firmly fixed.
110U (T-KJr2U) and 310U (T-K4U) models
9009069005
(TM-RE42)
Front of remote
Connect other end to these terminals
Installaon
Installaon Manual
Fig. D-1