Install Instructions
22 Page
TEMPERATURE REMOTE CONTROLLER
-INCLUDED ACCESSORIES-
<Mounting and wiring the remote controller>
1. Takeoffthe“Back plate” from the remote controller with a flat head screwdriver. (Fig. A and B)
2. Attachthe“Back plate” on the wall with the two provided screws. (Fig. B)
• This remote controller is NOT waterproof
Do not install in high temperature environments, steamy conditions (such as a
bath room), outdoors, in direct sunlight, or within the reach of children.
Make sure the remote controller does not come into contact with water or oil.
• Do not place the remote control wiring close to other wires from other
products.
• Do not extend the remote control wiring more than 400 ft. (122 m.)
CAUTION
Fig. B
Back plate
3-1/4 inches
Attach the screws
Cut out the partition with pliers
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
Check that these items below are included with the remote controller.
Temperature
remote controller*
Screws Manual Remote controller cable
Qty: 1 Qty: 2 Qty: 1
Qty: 1
-INSTALLATION-
Installaon
Installaon Manual
*9009069005 (TM-RE42)