User Guide
22 Page
REMOTE CONTROLLER CONNECTIONS
<How to connect the remote controller to the water heater>
1. Disconnect power supply from the water heater.
2. Take off the water heater’s front cover.
3. Wires used for the remote controller connection must be:
• Minimum 20 AWG wire (No polarity)
• 9007666005 (TK-RE02) for 110 (T-KJr2) & 310 (T-K4) models
Maximum 150 ft. long
9007603005 (TM-RE30) for 510 (T-D2) model
Maximum 400 ft. long
* For detailed connection to the remote controller, refer to the instructions that are packaged with
the remote controller.
4. Pick location of install for the remote controller.
5. Cut enough two pair wire.
6. Crimp on supplied fork connectors.
7. Locate the remote controller terminals, pictured below (located around the lower right-hand side
of the computer board).
8. Open the plastic cover of the remote controller, and then attach the two fork terminals to
connector base of the backside of the remote controller with two screws. Make sure the termi-
nals are firmly fixed.
9. Pull the remote’s wires through the hole at the bottom of the water heater’s casing.
10. Properly attach the remote’s wires to the remote controller terminals on the computer board.
(No polarity)
* Do NOT jump or short-circuit the wires, or the computer board will be damaged.
11. Replace the plastic computer board cover and then replace the front cover securely.
Installaon
Installaon Manual
Connect to these
terminals
9007666005(TK-RE02)
Front of
remote controller
110 (T-KJr2) & 310 (T-K4) models
Back of
remote
Connect to these
terminals
510 (T-D2) model
9007603005(TM-RE30)
Front of
remote controller
Back of
remote
Connect to these
terminals
Connect to these
terminals