Manual

Installation
22│Page

REMOTECONTROLLERCONNECTIONS

<Howtoconnecttheremotecontrollertothewaterheater>
1.Disconnectpowersupplyfromthewaterheater.
2.Takeoffthewaterheater’sfrontcover.
3.Locatetheremotecontrollerterminal,picturedbelow(locatedaroundthelowerright‐hand
sideofthecomputerboard).
4.Opentheplasticcoveroftheremotecontroller,andthen attachthetwoforkter minals
to
connectorbaseofthebacksidetheremotecontrollerwithtwoscrews.Makesurethe
terminalsarefirmlyfixed.
5.Pulltheremote’swiresthroughtheholeatthebottomofthewaterheater’scasing.
6.Properlyattachtheremote’swirestotheremotecontrollerterminalonthecomputerboard.

(Nopolarity)
*DoNOTjumporshort‐circuitthewiresorcompute rwillbedamaged.

7.ReplaceFrontCoversecurely.
8.Wiresusedfortheremotecontrollerconnectionmustbe:
• Minimum18AWGwire(Nopolarity)
• Maximum400feetlong




*Fordetailedconnectioninstructionstotheremotecontroller,refertotheinstructionsthatare
packagedwiththeremotecontroller.
<T‐D2‐IN/OSmodels>
<T‐KJr2‐IN/OS&T‐K4‐IN/OSmodels>
Frontofremote
Backofremote
Connectotherendtotheseterminals
Connecttothese
terminals
TK‐RE02
Frontofremote
Backofremote
Connectotherendtotheseterminals
Connecttothese
terminals
TM‐RE30