Installation Sheet

24 Page
ELECTRICAL CONNECTIONS
 Ensure that circuit power is turned OFF before you complete the following steps.
 Follow the electrical code requirements of the local authority having jurisdiction. In
the absence of such requirements, follow the current edition of the National Electrical
Code ANSI/NFPA 70 in the U.S. or the current edition of CSA C22.1 Canadian Electrical
Code Part 1 in Canada
 When servicing or replacing parts within the water heater, label all wires prior to dis-
connection to facilitate an easy and error-free reconnection. Wiring errors can cause
improper and dangerous operation. Verify proper operation after servicing.
 Failure to follow these instructions can result in fire, electrical shock, or death.
WARNING
1. The water heater must be electrically grounded. Do not attach the
ground wire to either the gas or the water piping.
2. The water heater requires a 120 VAC, 60 Hz electrical power supply that
is properly grounded.
 A proper disconnect (i.e. on/off switch, power plug, etc.) controlling
the main power to the water heater must be provided for service
reasons. (Must comply with local codes.)
 Connect the power supply to the water heater exactly as shown in
the wiring diagram.
3. A green screw is provided in the junction box to ground the connection.
4. Can be hardwired or wired to a plug-in.
5. The use of a surge protector is recommended in order to protect the unit
from power surges.
Installaon
Installaon Manual
Connecting the remote controller to the water heater
1. Disconnect the power supply from the water heater.
2. Take off the water heater’s front cover.
3. Locate the two terminals for the remote controller inside the water heater.
4. Put the remote controller cable through the hole at the bottom of the water heater's casing from outside.
5. Connect the two terminals attached to the end of the remote control cables to the terminals near the
computer board as shown below. (No polarity)
* Do NOT jump or short-circuit the wires, or the computer will be damaged.
6. Replace the water heater's front cover securely.
Connect to these terminals.
Connect the other end to these terminals.
Front of remote
Back of remote
Remote controller terminals
of the water heater
Ground
Connect
power supply
120VAC/60HZ
REMOTE CONTROLLER CONNECTION
 This remote controller is NOT waterproof.
 The water heater can only have one remote controller.
 Do not install in high temperature environments, steamy conditions (such as a
bathroom), outdoors, in direct sunlight, or within the reach of children.
 Make sure the remote controller does not come into contact with water or oil.
 Failure to observe these warnings could result in electrical shock.
WARNING
This water heater can be connected to a remote controller 100112155 (TM-RE30). Refer to the instruc-
tions attached to the remote controller for details.
 Do not place the remote controller cable close to other wires from other products.
 Cables used for the remote controller connection must be:
 Minimum 20 gauge wire (No polarity)
 Maximum 400 ft (122 m) long
NOTICE