Product Specs

11
Ⅱ) Selecting a wireless channel
Set the locator and the monitor to the same wireless channel.
※The minus mark [-] as indicated in the figure below means that the transmission is off.
In the case of poor reception quality or interference, please change to a different channel.
Ⅲ) Selecting the transmitter
The transmitter has three available frequencies. Select the most suitable frequency for your jobsite.
For details, please refer to section 3) - “Measuring noise”.
Ⅳ) Depth Correction (Calibration)
Navigate to the calibration icon in the top right corner of the screen and press MODE to select.
For details, refer to section 2) - “Depth correction (Calibration)”.
a) Navigate to the wireless icon
in the menu and press
MODE button to select.
b) Toggle between channels
using the GAIN (▲) and
L/R (▼) button.
a) Navigate to transmitter icon
in the bottom right corner
and press MODE to select.
b) Toggle between
frequencies using GAIN
(▲) and L/R (▼) button.
1
2
3
4
c) Press MODE again
and return to the
measurement screen.
c) Press MODE again
and return to the
measurement screen.
- T14 -
- T9 -
- T38 -
- T38 -