User's Manual
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in conventional mode
- 6 Operating in trunked mode
- 7 Dialing calls in trunked mode
- 8 GPS location services
- 9 Loneworker monitoring
- 10 Encryption
- 11 Customizing radio settings
- 12 Charging and caring for batteries
- 13 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
18 For your safety
DRAFT 4
■ Gas Group IIC and Dust Group IIIC-rated acces-
sories may be used with Gas Group IIA or IIC
radios, but the combination may only be used in a
Gas atmosphere.
Any item approved to IIA will limit the radio system to
a IIA area. For use in a IIC area, all items must be
approved to IIC.
Radio installation and operation in
vehicles
Warning Keep the radio away from airbags and
airbag deployment areas. Do not install, charge, or
place a radio near such areas. An activated airbag
can propel a portable radio with sufficient force to
cause serious injury to vehicle occupants. An airbag
may not perform to specification if obstructed by a
radio.
Warning To avoid damage to existing wiring, airbags,
fuel tanks, fuel and brake lines, or battery cables, refer
to the installation guide for the radio, and to the vehicle
manufacturer’s manual, before installing electronic
equipment in the vehicle.
Using a handheld microphone or a radio while driving
a vehicle may violate the laws and legislation that
apply in your country or state. Please check the
vehicle regulations in your area.
Vehicle charger installation and
operation
For detailed instructions necessary to the safe
installation and operation of the vehicle charger,
please refer to the documentation supplied with the
vehicle charger.