User's Manual

146 Troubleshooting
DRAFT 2
Test Description
Audio loopback
test
Routes audio from an external accessory
microphone to the radio's internal speaker.
Before running this test, turn the volume down to
limit interference and reduce the impact of audio
artefacts.
Display freq Displays the transmit and receive frequencies of the
current channel. If the radio is scanning this
information may not be available.
GPS NMEA
data
Displays the last raw data received from the radio’s
internal GPS. The radio will display all supported
sentence formats received (for example $GPRMC
and $GPGGA sentences). Note that the display will
not automatically refresh when new data is received.
Keypad test Sounds an audible tone when a key is pressed or
released on the radio, or the 16-way and 3-way
selectors are moved. The radio also displays the
key or selector name along with “pressed” or
“released” or the new selector position.
QoS Displays information about the quality of service
(received signal strength (RSSI) with an indication of
digital voice quality).
RSSI Displays the received signal strength (RSSI) of the
current channel.
Rx Tone Receives a 1011 Hz or 1031 Hz tone and displays
the received signal strength (RSSI) and the bit error
rate (BER) of the received signal.
Site display Shows the channel number, signal strength and
system-identity code (SYSCODE) for the currently
registered trunked site.
Site measure Lists the current trunked site (indicated with an
asterisk) and up to six detected adjacent sites, with
received signal strength (RSSI) information.
Tone test Generates an audible tone for the duration of the
test.
Tx Tone Transmits a tone of 1011 Hz or 1031 Hz on the
current P25 channel.
Tx Tone Cal Transmits a 1011 Hz or 1031 Hz tone on the current
channel with a bit error rate (BER) of 5%.
Tx power test Displays hardware-related information while the
radio is transmitting. Information includes the final
PA current (in mA)