User's Manual
Table Of Contents
- TP9400 User’s Guide DRAFT
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in conventional mode
- 6 Operating in P25 trunking mode
- 7 Editing a scan group
- 8 P25 services
- 9 Emergency operation
- 10 Encryption
- 11 Customizing radio settings
- 12 Charging and caring for batteries
- 13 Troubleshooting
- 14 Glossary
- Index
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
84 P25 services
Messages
You may be able to send short messages to another
radio user. These messages are defined at programming
time and are also known as ‘pre-programmed messages’.
The person to whom you are sending the message must
have the same message programmed into their radio in
order to read and display your message.
Sending a message
You may be able to send your message to a
predetermined person or talkgroup, or to a person of
your choice.
Sending a message to a predetermined
person or talkgroup
1 Press Menu and select Services > Messages.
(Depending on how your radio is programmed, you
may be able to press a function key or use your Quick
Access menu to select messages.)
2 Select the message you want from the message list.
3 Press Select.
A message showing the destination appears in the
display.
The LED glows red and a message may be displayed
to advise you whether the message has been sent
successfully or not.
Messages
En route
At scene
SelectCancel
Sending
message to
current group
Cancel