User's Manual
Table Of Contents
- TP9400 User’s Guide DRAFT
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in conventional mode
- 6 Operating in P25 trunking mode
- 7 Editing a scan group
- 8 P25 services
- 9 Emergency operation
- 10 Encryption
- 11 Customizing radio settings
- 12 Charging and caring for batteries
- 13 Troubleshooting
- 14 Glossary
- Index
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
62 Operating in conventional mode
Suspending a channel from a scan group
If a member channel of a scan group is busy for a long
time and you do not want to hear the conversation, you
may be able to use the function key programmed for
nuisance delete to temporarily delete it from the scan
group. When the scan group is next selected, or after the
radio has been turned off and then on, the deleted
channel is again part of the scan group.
To remove a channel from a scan group:
1 Wait until the radio has stopped on the channel that
you want to remove from the scan group.
2 Press the function key programmed for
nuisance delete.
If the channel has been removed successfully, the
message Channel nuisance deleted appears in the
display.
The channel remains removed from the scan group
until you either select another scan group or the
radio is turned off and then on again.
The function key programmed to activate scanning may
be programmed so that a short key press activates
scanning and a long key press activates nuisance delete.
Channel
nuisance
deleted