User's Manual
Table Of Contents
- TP9400 User’s Guide DRAFT
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in conventional mode
- 6 Operating in P25 trunking mode
- 7 Editing a scan group
- 8 P25 services
- 9 Emergency operation
- 10 Encryption
- 11 Customizing radio settings
- 12 Charging and caring for batteries
- 13 Troubleshooting
- 14 Glossary
- Index
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
54 Operating in conventional mode
Receiving a two-tone call
This feature is available for analog channels only.
Two-tone signaling is used to call either individual or
groups of radios. When your radio receives a two-tone
call that it can decode, it beeps, indicating which type of
two-tone call has been received.
■ One long beep: a two-tone individual call has been
received.
■ Two medium beeps: a two-tone group call has been
received.
■ Three short beeps: a two-tone super group call has
been received. A super-group call is addressed to all
radios in the fleet.
To accept the call, press the PTT key and begin
speaking.
Overriding two-tone signaling
You can override two-tone signaling using a function
key, if your radio is programmed in this way.
■ Press the function key to override two-tone
signaling on a channel, and hear all two-tone calls.
The message Ignore two-tone activated
(or deactivated) appears in the display.