User's Manual
Table Of Contents
- TP9400 User’s Guide DRAFT
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in conventional mode
- 6 Operating in P25 trunking mode
- 7 Editing a scan group
- 8 P25 services
- 9 Emergency operation
- 10 Encryption
- 11 Customizing radio settings
- 12 Charging and caring for batteries
- 13 Troubleshooting
- 14 Glossary
- Index
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
Charging and caring for batteries 123
LED behavior
If there is a battery in the charger when power is
supplied to the charger, the LEDs behave as follows:
If the charger does not behave as expected:
■ Make sure the radio or battery is seated properly in
the charger.
■ Check that the charger is properly plugged in.
■ Check that the battery and charger contacts are
clean. To clean, wipe the contacts with a dry lint-free
cloth to remove any dirt, oil or grease.
LED Meaning
briefly
The charger has been connected to a power
supply.
steady
The battery is charging.
steady
Charging complete. Remove the battery, or
leave it in the charger.
steady
■ The battery temperature is outside the
normal charging range. Charging will
start or resume once the temperature is
within normal limits. No action is
required.
■ There is a fault. Contact your local
regional Tait office.
all off
There is a fault. Contact your local regional
Tait office.