User's Manual
Table Of Contents
- TP9400 User’s Guide DRAFT
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in conventional mode
- 6 Operating in P25 trunking mode
- 7 Editing a scan group
- 8 P25 services
- 9 Emergency operation
- 10 Encryption
- 11 Customizing radio settings
- 12 Charging and caring for batteries
- 13 Troubleshooting
- 14 Glossary
- Index
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
122 Charging and caring for batteries
Charging the battery
Fully charge a battery before using it for the first time.
This will take up to 2.5 hours.
The red LED stays lit while the battery charges.
To charge the battery:
1 Desktop charger: Connect the charger to the correct
Tait power adaptor.
Multicharger and vehicle charger: Power on the
charger.
Initially, all three LEDs are lit for two seconds.
2 Place just a battery in the charger, or a radio with a
battery attached (desktop charger or multicharger
only). There is no need to remove a belt clip, antenna,
or any accessory that is attached to the accessory
connector.
The red LED lights up, and stays lit while the battery
charges. For a battery that is almost completely
discharged, allow two hours.
When charging is complete, the green LED
stays lit.