User's Manual
Table Of Contents
- TP9300 User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in trunked mode
- Checking that your network is available
- Making a preset call
- About trunked zones and workgroups
- About emergency operation
- Dialing a PABX number
- Dialing a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About trunked text messages
- Placing the radio in do-not-disturb mode
- Calls to conventional channels or conventional groups
- 6 Dialing calls in trunked mode
- 7 Operating in conventional mode
- Selecting a zone
- Selecting a channel
- Selecting a group
- Checking that a channel is clear
- Making a call
- Making a call using the address book
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Transmitting at low power
- Ending active calls
- Activating the repeater before a call
- Communicating directly with other radios
- Receiving a call
- Receiving a text message
- Hearing faint and noisy signals
- Using the radio in different repeater areas
- Scanning a group of channels
- 8 Customizing radio settings
- 9 Charging and caring for batteries
- 10 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
84 Operating in conventional mode
Making a local call
Each channel on your radio may have one or more local
calls programmed.
Using the Main menu
1 Select the required channel.
2 Select Menu > Local calls.
3 In the Local Calls menu, scroll through the list of local
calls until the call you want appears.
4 Press Send.
The call details appear in the display, the LED glows
red, and appears in the display.
Using the Quick Access menu
1 Select the required channel.
2 Press one of the scroll keys or the left selection key
to open the Local Calls menu.
3 Scroll through the list of local calls until the call you
want appears.
4 Press Send.
The call details appear in the display, the LED glows
red, and appears in the display.
SelectBack
Main menu
Local calls
Set status