User's Manual
Table Of Contents
- TP9300 User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in trunked mode
- Checking that your network is available
- Making a preset call
- About trunked zones and workgroups
- About emergency operation
- Dialing a PABX number
- Dialing a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About trunked text messages
- Placing the radio in do-not-disturb mode
- Calls to conventional channels or conventional groups
- 6 Dialing calls in trunked mode
- 7 Operating in conventional mode
- Selecting a zone
- Selecting a channel
- Selecting a group
- Checking that a channel is clear
- Making a call
- Making a call using the address book
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Transmitting at low power
- Ending active calls
- Activating the repeater before a call
- Communicating directly with other radios
- Receiving a call
- Receiving a text message
- Hearing faint and noisy signals
- Using the radio in different repeater areas
- Scanning a group of channels
- 8 Customizing radio settings
- 9 Charging and caring for batteries
- 10 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
52 Operating in trunked mode
Selecting a workgroup
1 Select Menu > Set workgroup.
(Depending on how your radio is programmed, you
may be able to use the scroll keys, left selection key
or channel selector to select a workgroup.)
2 In the Set Workgroup menu, scroll through the list of
workgroups until the workgroup you want appears.
3 Press Select.
4 Check that the network icon appears in the
display.
Making a call to a workgroup
Different types of calls may be associated with your
workgroups. These calls can be individual calls, preset
calls, broadcast calls (no response permitted), or
conference calls.
To make a call to a workgroup:
1 Select the required zone. See “Selecting a zone” on
page 51.
2 Select the required workgroup. See “Selecting a
workgroup” on page 52
3 Press the PTT key, and a call to that workgroup is
made.
SelectBack
Main menu
Set workgroup
Go to homegroup