User's Manual
Table Of Contents
- TP9300 User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in trunked mode
- Checking that your network is available
- Making a preset call
- About trunked zones and workgroups
- About emergency operation
- Dialing a PABX number
- Dialing a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About trunked text messages
- Placing the radio in do-not-disturb mode
- Calls to conventional channels or conventional groups
- 6 Dialing calls in trunked mode
- 7 Operating in conventional mode
- Selecting a zone
- Selecting a channel
- Selecting a group
- Checking that a channel is clear
- Making a call
- Making a call using the address book
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Transmitting at low power
- Ending active calls
- Activating the repeater before a call
- Communicating directly with other radios
- Receiving a call
- Receiving a text message
- Hearing faint and noisy signals
- Using the radio in different repeater areas
- Scanning a group of channels
- 8 Customizing radio settings
- 9 Charging and caring for batteries
- 10 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
16 For your safety
instructions. Interference with blasting operations could
cause serious injury or death.
Radio installation and operation in vehicles
Warning Keep the radio away from airbags and airbag
deployment areas. Do not install, charge, or place a radio
near such areas. An activated airbag can propel a
portable radio with sufficient force to cause serious
injury to vehicle occupants. An airbag may not perform
to specification if obstructed by a radio.
Warning To avoid damage to existing wiring, airbags,
fuel tanks, fuel and brake lines, or battery cables, refer to
the installation guide for the radio, and to the vehicle
manufacturer’s manual, before installing electronic
equipment in the vehicle.
Using a handheld microphone or a radio while driving a
vehicle may violate the laws and legislation that apply in
your country or state. Please check the vehicle
regulations in your area.
Vehicle charger installation and operation
For detailed instructions necessary to the safe
installation and operation of the vehicle charger, please
refer to the documentation supplied with the vehicle
charger.
Multicharger safety information
Warning This device must be connected to an earthed
mains socket-outlet.
Norsk (no): Apparatet må tilkoples jordet stikkontakt.
Suomi (fi): Laite on liitettävä
suojamaadoituskoskettimilla varustettuun pistorasiaan.
Svenska (sv): Apparaten skall anslutas till jordat uttag.