User's Manual
Table Of Contents
- TP9300 User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in trunked mode
- Checking that your network is available
- Making a preset call
- About trunked zones and workgroups
- About emergency operation
- Dialing a PABX number
- Dialing a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About trunked text messages
- Placing the radio in do-not-disturb mode
- Calls to conventional channels or conventional groups
- 6 Dialing calls in trunked mode
- 7 Operating in conventional mode
- Selecting a zone
- Selecting a channel
- Selecting a group
- Checking that a channel is clear
- Making a call
- Making a call using the address book
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Transmitting at low power
- Ending active calls
- Activating the repeater before a call
- Communicating directly with other radios
- Receiving a call
- Receiving a text message
- Hearing faint and noisy signals
- Using the radio in different repeater areas
- Scanning a group of channels
- 8 Customizing radio settings
- 9 Charging and caring for batteries
- 10 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
For your safety 13
■ Regional Planning channels, as defined in
§ 90.531 (b) (3).
■ Itinerant channels, as defined in § 90.531 (b) (4).
Use of encryption
This radio complies with § 90.553 (a) of 47 CFR. This
states that:
■ Encryption is not permitted on the nationwide
Interoperability calling channels. These channels are
defined in § 90.531 (b) (1) (ii).
■ Radios using encryption must have a readily
accessible switch or control to allow the radio user
to disable encryption.
EMC regulatory compliance in Australia
This product meets all ACMA regulatory requirements
for electromagnetic compatibility (EMC). For more
information about EMC compliance, visit the ACMA
website at www.acma.gov.au.
Frequency band reserved for
distress
beacons
Frequency band 406 to 406.1 MHz is reserved for use by
distress beacons. Transmissions should not be made
within this frequency band.
Health, safety and electromagnetic
compatibility in
Europe
In the European Community, radio and
telecommunications equipment is regulated by
Directive 1999/5/EC, also known as the Radio and
Telecommunications Terminal Equipment (R&TTE)
directive. The requirements of this directive include