User's Manual
Table Of Contents
- TP9300 User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in trunked mode
- Checking that your network is available
- Making a preset call
- About trunked zones and workgroups
- About emergency operation
- Dialing a PABX number
- Dialing a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About trunked text messages
- Placing the radio in do-not-disturb mode
- Calls to conventional channels or conventional groups
- 6 Dialing calls in trunked mode
- 7 Operating in conventional mode
- Selecting a zone
- Selecting a channel
- Selecting a group
- Checking that a channel is clear
- Making a call
- Making a call using the address book
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Transmitting at low power
- Ending active calls
- Activating the repeater before a call
- Communicating directly with other radios
- Receiving a call
- Receiving a text message
- Hearing faint and noisy signals
- Using the radio in different repeater areas
- Scanning a group of channels
- 8 Customizing radio settings
- 9 Charging and caring for batteries
- 10 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
12 For your safety
CFR Title 47 Part 15.19 (a) (3) - All other
devices
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Radio frequency emissions limits in Canada
This device complies with Industry Canada licence
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
USA public safety bands
(764 –776 MHz and 794 – 806 MHz)
The Code of Federal Regulations (CFR) Title 47
Subpart R deals with the use of frequencies in the 764 to
776 MHz and 794 to 806 MHz bands.
Low-power channels
This radio complies with § 90.531 (b) (3) and
§ 90.531 (b) (4) of 47 CFR. These sections state that only
low-power transmission is permitted on the
following channels: