User's Manual
Table Of Contents
- TP9300 User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in trunked mode
- Checking that your network is available
- Making a preset call
- About trunked zones and workgroups
- About emergency operation
- Dialing a PABX number
- Dialing a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About trunked text messages
- Placing the radio in do-not-disturb mode
- Calls to conventional channels or conventional groups
- 6 Dialing calls in trunked mode
- 7 Operating in conventional mode
- Selecting a zone
- Selecting a channel
- Selecting a group
- Checking that a channel is clear
- Making a call
- Making a call using the address book
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Transmitting at low power
- Ending active calls
- Activating the repeater before a call
- Communicating directly with other radios
- Receiving a call
- Receiving a text message
- Hearing faint and noisy signals
- Using the radio in different repeater areas
- Scanning a group of channels
- 8 Customizing radio settings
- 9 Charging and caring for batteries
- 10 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
116 Charging and caring for batteries
LED behavior
If there is a battery in the charger when power is
supplied to the charger, the LEDs behave as follows:
If the charger does not behave as expected:
■ Make sure the radio or battery is seated properly in
the charger.
■ Check that the charger is properly plugged in.
■ Check that the battery and charger contacts are
clean. To clean, wipe the contacts with a dry lint-free
cloth to remove any dirt, oil or grease.
LED Meaning
briefly
The charger has been connected to a power
supply.
steady
The battery is charging.
steady
Charging complete. Remove the battery, or
leave it in the charger.
steady
■ The battery temperature is outside the
normal charging range. Charging will
start or resume once the temperature is
within normal limits. No action is
required.
■ There is a fault. Contact your local
regional Tait office.
all off
There is a fault. Contact your local regional
Tait office.