User's Manual
Table Of Contents
- TP9300 User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Operating in trunked mode
- Checking that your network is available
- Making a preset call
- About trunked zones and workgroups
- About emergency operation
- Dialing a PABX number
- Dialing a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About trunked text messages
- Placing the radio in do-not-disturb mode
- Calls to conventional channels or conventional groups
- 6 Dialing calls in trunked mode
- 7 Operating in conventional mode
- Selecting a zone
- Selecting a channel
- Selecting a group
- Checking that a channel is clear
- Making a call
- Making a call using the address book
- Making a local call
- Connecting to a telephone network
- Making an emergency call
- Sending a status message
- Transmitting at low power
- Ending active calls
- Activating the repeater before a call
- Communicating directly with other radios
- Receiving a call
- Receiving a text message
- Hearing faint and noisy signals
- Using the radio in different repeater areas
- Scanning a group of channels
- 8 Customizing radio settings
- 9 Charging and caring for batteries
- 10 Troubleshooting
- Directive 1999/5/CE Declaration of Conformity
- Tait Software Licence Agreement
100 Operating in conventional mode
■ Press and hold the function key programmed for
scanning to remove the current channel from the
scanning group.
If the operation has been successful, the message
Channel deleted from group appears in the display.
Adding or deleting member channels of a
group
Your radio may be programmed so you can add or delete
channels in a voting or scanning group. Changes made
are permanent, and will remain after restarting the radio.
1 Select the group. See “Selecting a group” on page 79.
2 Press Edit.
If there is no edit option for the left selection key, the
group cannot be changed.
Alternatively, you may be able to edit groups by
selecting Menu > Advanced > Program groups, then
select the group you wish to edit.
3 In the Edit Group menu, choose Add channel or
Delete channel.
4 Press Select.
5 Press the scroll keys to select the channel that you
want to add or delete.
6 Press OK.
If successful, the message Channel added or
Channel deleted appears.
To check the new group details, press Back and
select the Group members menu option.
Changing a group’s transmit channel
You may be able to change the transmit channel of a
standard scanning group. The transmit channel is
identified by the icon.
1 Select the group. See “Selecting a group” on page 79.