User's Manual
Table Of Contents
- Front cover
- Directive 1999/5/EC Declaration of Conformity
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RFenergy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in theUSA
- Unapproved modifications or changes toradio
- Health, safety and electromagnetic compatibility inEurope
- Electromagnetic compatibility in European vehicles
- Interference with electronic devices
- Frequency band reserved for distressbeacons
- Safe radio operation
- Navigating your radio’s menus
- Contents
- Before using your radio
- Getting started
- Basic operation
- Making and receiving different typesofcalls
- Making an individual or group call
- Resending calls automatically
- Receiving an individual orgroupcall
- Responding to missed calls
- Informing other radio users of your status
- Calling a telephone or a remotedevice
- Making an emergency call
- Activating the automated emergency call feature
- Sending and receiving text messages
- Changing your radio’s settings
- Charging and caring for batteries
- Troubleshooting
- Function key options
- Tait general software licence agreement
- Rear cover
18 Before using your radio
To remove the battery pack:
1 Press the battery catch down.
2 From the sides, pull the battery away from the radio.
Attaching the antenna
Before using the radio, screw the antenna clockwise into the
antenna connector. The antenna should be screwed suffi-
ciently tight so that it doesn’t unscrew easily. This is impor-
tant as it creates a seal.
Attaching a belt clip
To attach a belt clip to your radio:
1 Slide the belt clip into the two grooves at the top of the
battery.
2 Press down on the belt clip until it snaps into place.
See also “Removing a belt clip” on page 61.
Removing the accessory cover
To fit some accessories to the radio, you will need to remove
the accessory cover, using a coin.
belt clip
battery