User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- Safety and compliance warnings
- Radio frequency exposure information
- Radio frequency emissions limits in the USA
- Health, safety and electromagnetic compatibility inEurope
- Electromagnetic compatibility in European vehicles
- EN60950 requirements (25 watt radios)
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- About this guide
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About emergency operation
- Dialling a pabx number
- Dialling a pstn number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
66 Troubleshooting
Reinstalling the microphone
Caution: The microphone grommet must be installed when-
ever the microphone is plugged into the micro-
phone socket.
1 Plug the microphone into the microphone socket.
2 Slide the microphone grommet along the microphone
cord and push two adjacent corners of the grommet into
the microphone socket cavity.
3 Squeeze the grommet and push the remaining corners
into position.
4 Check that the grommet is seated correctly in the cavity.
Removing the radio from the vehicle
1 Switch off the radio.
2 Unscrew the four thumb screws that secure the radio
to the U-bracket .
3 Carefully lift the radio clear of the U-bracket.
4 Disconnect the antenna and power cable from
the rear of the radio.
microphone
grommet
control head
c
d
a
a
b
a
b
c
d