User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- Safety and compliance warnings
- Radio frequency exposure information
- Radio frequency emissions limits in the USA
- Health, safety and electromagnetic compatibility inEurope
- Electromagnetic compatibility in European vehicles
- EN60950 requirements (25 watt radios)
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- About this guide
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About emergency operation
- Dialling a pabx number
- Dialling a pstn number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
Operating in MPT trunked mode 53
Accessing the call queue
1 Use the scroll keys or to move through the
calls in the call queue until the call you want appears.
2 Press Options to open the Call
Queue Options menu.
The options available for the call
depend on the type of call it is. If
the call is a voice call, select Call
to return the call or Delete to delete the call.
If the call is a status message or
a text message, then select
View to read the message.
Changing your call queuing setting
Your radio may be programmed so that you are able to
change call queuing to “unanswered”. Unanswered call
queuing means that all status and text messages are imme-
diately queued. Incoming voice calls are only queued if they
are unanswered.
If your radio has a keypad microphone installed, you may be
able to change your call queuing setting using the keypad. For
information about entering characters using the keypad micro-
phone, see “About the keypad microphone” on page 17.
To activate call queuing:
■ select Menu>Radio settings>Call settings>Call queuing
and choose On, or
■ dial *48 then press the or PTT key.
The message Call queuing activated appears.
To change call queuing to unanswered call queuing:
■ select Menu>Radio settings>Call settings>Call queuing
and choose Off, or
■ dial #48 then press the or PTT key.
The message Call queuing deactivated appears.