User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- Safety and compliance warnings
- Radio frequency exposure information
- Radio frequency emissions limits in the USA
- Health, safety and electromagnetic compatibility inEurope
- Electromagnetic compatibility in European vehicles
- EN60950 requirements (25 watt radios)
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- About this guide
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About emergency operation
- Dialling a pabx number
- Dialling a pstn number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
Operating in conventional mode 41
While emergency mode is active, your radio may cycle
between receive and transmit, so that your dispatcher
can hear any activity near the radio. Alternatively, your
radio may appear to turn off but will actually remain in
emergency mode.
2 Reset the radio to normal operation at any time
by turning the radio off and then on.
Note: Emergency mode may be programmed to end after a
fixed period of time. In this case, there is no need to
turn the radio off and then on in order to return the
radio to normal operation.
Receiving a call
When there is valid activity on your radio’s currently selected
channel or group, the radio then unmutes and you can
hear the call.
If the incoming call contains special signalling that matches
the signalling programmed for your radio, the green LED
flashes and your radio may give a ringing tone.