User's Manual
Table Of Contents
- Directive 1999/5/EC Declaration of Conformity
- About this guide
- For your safety
- Safety warnings used in this guide
- Radio frequency exposure information
- Controlling your exposure to RF energy
- Compliance with RF energy exposure standards
- Radio frequency emissions limits in the USA
- Unapproved modifications or changes to radio
- Health, safety and electromagnetic compatibility in Europe
- Electromagnetic compatibility in European vehicles
- EN 60950 requirements (25 watt radios)
- Interference with electronic devices
- AS/NZS 4365 requirements
- Frequency band reserved for distress beacons
- Safe radio operation
- High radio surface temperatures
- Radio protection when charging the vehicle battery
- GPS operation
- Your radio’s settings
- Contents
- Getting started
- Basic operation
- Operating in conventional mode
- Operating in MPT trunked mode
- Changing your operating mode
- Checking that your network is available
- Changing your network
- Making a preset call
- About talkgroups and scan groups
- Making a talkgroup call
- Changing group membership
- Making an emergency call
- Dialling a PABX number
- Dialling a PSTN number
- Receiving a call
- Re-establishing a call
- Checking missed calls
- About status messages
- About text messages
- Calls to conventional channels or groups
- Dialling calls in MPT trunked mode
- Troubleshooting
- Tait general software licence agreement
For your safety 9
Compliance with RF energy exposure standards
This two-way radio complies with these RF energy exposure
standards and guidelines:
■ United States Federal Communications Commission,
Code of Federal Regulations; 47 CFR 1.1307, 1.1310
and 2.1091
■ American National Standards Institute (ANSI) / Institute
of Electrical and Electronic Engineers (IEEE) C95. 1-1992
■ Institute of Electrical and Electronic Engineers (IEEE)
C95.1-1999 Edition.
This radio complies with the IEEE (FCC) and ICNIRP exposure
limits for occupational/controlled RF exposure environments
at operating duty factors of up to 50% talk to 50% listen.
Radio frequency emissions limits in the USA
Part 15 of the FCC Rules imposes RF emission limits on
electronic equipment to prevent interference to reception of
broadcast services.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the condition that this device does
not cause harmful interference.
Note:
Changes or modifications to this device that are not
expressly approved by Tait Electronics Limited may make its use
illegal.
Unapproved modifications or changes to radio
The radio is designed to satisfy the applicable compliance
regulations. Do not make modifications or changes to the
radio that are not expressly approved by Tait Electronics
Limited. Failure to do so could invalidate compliance
requirements and void the user’s authority to operate
the radio.